Learning Center
Maintenance routines for compact skid steer loaders and attachments, focused on inspections, lubrication, fluids, wear points, storage, and service records.
Check engine oil, coolant where applicable, hydraulic oil, fuel level, visible filters, tire or track condition, attachment locks, hoses, fittings, pins, bushings, battery condition, lights, and warning labels before the machine enters the work area.
Grease loader-arm pivots, bucket pins, coupler mechanisms, cylinder ends, and attachment moving points on a consistent schedule. Grease after washing or heavy mud work so water and grit are pushed out of pivot areas.
Look for cracked covers, exposed wire braid, wet fittings, flattened hose sections, rubbing marks, or tight bends. Replace damaged hoses before they fail under pressure.
Follow the machine manual for oil and filter intervals. Use the correct oil type and keep fill areas clean so dirt does not enter the engine, fuel system, or hydraulic reservoir during service.
Inspect cutting edges, bucket teeth, auger flights, broom bristles, grapple tines, mower blades, and land-leveler edges. Worn ground-contact parts reduce productivity and can stress the machine.
Store attachments on level ground, cap hydraulic lines, clean mud from working edges, and record hours, services, repairs, and parts used. Good service records make support and warranty conversations faster.
Use these links to move from training guidance into machine selection, attachment fitment, technical support, or a quote request.
